If you use the Lumina or Lumina Pro to control your home's lighting or the Omni IIe or OmniPro II to control security and surveillance in addition to lighting, you can monitor and control your home's systems remotely across a network or over the Internet. HAI's Snap-Link software can be installed on any PC as a conventional application or it can run from the included thumb drive. Simply insert the Snap-Link into a remote computer with an Internet connection, and you'll be able to monitor and control lights, security, temperatures, and IP cameras at your home. Easy One-Time Setup Snap-Link is easy to use and easy to set up because it is self-contained on the USB drive. Enter your HAI system's IP address and data, and you'll be able to control it from any computer at any time. Just plug the USB drive into any Internet-connected computer to access Snap-Link. There is no installation necessary, and when you are finished, just unplug the drive. No residue of the application is left on the remote computer. Snap-Link uses 128-bit encryption, and it requires no subscription or fees. Control Any Connected Device Remotely The Snap-Link home page displays an overall summary of your system. This page allows you to set the system time, change security mode, control any temperature devices connected to your system, and view any currently displayed messages. Access your surveillance cameras to view the events around your home. Snap-Link also displays a list of the most recent System Events. Simply select an item to view its available commands. Set Up E-Mail Alerts You can set up Snap-Link to send alerts via e-mail, cell phone, or pager, based upon specified events in your home. Snap-Link can pop up a message dialog and/or send an e-mail when an alert is triggered. Since most cell phones and alphanumeric pagers have an e-mail address associated with them, this means that you can receive notifications on your phone or pager.