Rain8 Sprinkler Controller & Powerlinc_1

Control sprinkler zones like any other X10 connected device
Multiple units can be networked for larger installations
Configure entire sprinkler program as a single X10 address, or assign X10 address to each sprinkler zone
Essential Info
Integrate sprinkler or watering system control into your X10 home automation system with the Rain8, a full-featured, 8-zone irrigation controller that accepts and reacts to standard X10 commands. This opens up the world of sprinkler and irrigation system control to anyone with X10 timers, remote controls, even over-the-Internet control using PC-based automation software.

Easy Setup
Setup is easy. All you have to do is momentarily connect the Rain8 to your PC's serial port to assign the X10 address and program cycle durations for each sprinkler zone. Once the X10 address and zone cyle durations have been set, the Rain8 can be disconnected from the PC and will respond to X10 signals just like any other X10-connected device (requires PowerLinc (#1132B) or TW523 (#1135) module, sold separately). The Rain8 does not have to be connected to a PC for everyday operation.


Manuals/Software
Rain8 Instruction Manual
Troubleshooting Guide
What's Included
Rain8

PowerLinc module

Standard 4 conductor RJ-11 crossover phone cable